-
S70037 Harland Sharp 1.7 Non Adjustable
SOLD
Have a set of new unused (mocked up) 1.7 roller rockers I was going to use I purchased very early in my build.
The build grew and I ended up getting a custom camshaft ground for 1.6 rockers so these got mocked up but were never run.
Admittingly, I did leave them in the garage and about half of the rollers got surface rust on a portion of the roller tip. I had contacted Randy at Harland Sharp and he assured me that after some scotch brite with WD-40 they would be fine but if I wanted him to he would replace each roller for $4 a piece.
I think less than half had a little bit of surface rust on them. If you message me your number I will text you pictures.
SOLD
Thanks!
Thomas
Last edited by thomasfouraker; 06-15-2021 at 01:32 PM.
-
-
Posting Permissions
- You may not post new threads
- You may post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules