M1 fresh from powdercoat, ready to install.
Intake.jpg
M1 fresh from powdercoat, ready to install.
Intake.jpg
Last edited by musky mike; 06-10-2021 at 08:45 PM.
Looks killer Mike!
2003 Dakota R/T CC Flame Red. Bolt ons, Built Trans.
Dynotune Nitrous Wet system, 100 shot, FRP tuned. (SOLD! Gone but never forgotten)
Acts 2:38
Looks great. (Though i was expecting a methanol thread )
Better than I remember it!
Local shop charges $150. I think that is a great price, it would take me a few hours to clean it up and then spray it with hi temp paint. Powdercoating should be a lot more durable than hi temp paint.
Last edited by musky mike; 06-10-2021 at 08:46 PM.
I powdercoated mine, of course where I worked at, we had a powdercoating shop
At least kill that ridge in the plenum. Fix a piss poor manifold inside, then make it pretty on the outside.
11.27 @ 118.232017 NM Mopar Challenge Series Champion
DSC01289.JPG
20 years ago.. Ceramicoated.. Hadn't looked at these old pictures in a while, could have sworn I had a 2bbl intake, but looks like I it was a 4bbl with adapter.
Mike Williams
#001
98 DA RC GrapeJuice
99 BLK CC (Buy Back)
00 BLK RC ProCharged -Hotchkis - on and on (Sold)
01 AF CC (Leased - Turned in)
99 DA CC R/T
13.97@100 w/modded kegger & ported TB
12.96 @103
10:8-1 .30 over forged bottom end
R/T ported heads
Detroit locker 4:56 gears
Built 46RE MSaine 3500 stall Ultra Billet
http://imgur.com/a/lOVuZ