+ Reply to Thread
Results 1 to 4 of 4

Thread: M1 2bbl/4bbl inlet position and height compared to keg

  1. #1

    Default M1 2bbl/4bbl inlet position and height compared to keg

    My understanding has been that with the M1 being a direct factory replacement that the height and the positioning of the inlet at the top of the intake be it (2bbl or 4bbl w or without adapter) would sit in the same place as the stock kegger, correct? I'm running a shaker hood so I need to make sure it all lines up to seal right.

    If this has been answered somewhere over the last 20 years and I missed it apologize in advance.

    I appreciate the insights.

  2. #2

    y2krtaf's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Jan 2008
    Location
    Phoenix, Az
    Posts
    3,472

    Default

    For the 2bbl,yes. For the 4bbl,you will need a 1” spacer to achieve the same height.

  3. #3

    Default

    Perfect, exactly what I needed to know.

    Thanks

  4. #4


    99dart's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Feb 2008
    Location
    Washington...the hot side!
    Posts
    3,886

    Default

    Good answer, Gary!
    99 DA CC R/T
    13.97@100 w/modded kegger & ported TB
    12.96 @103
    10:8-1 .30 over forged bottom end
    R/T ported heads
    Detroit locker 4:56 gears
    Built 46RE MSaine 3500 stall Ultra Billet
    http://imgur.com/a/lOVuZ

+ Reply to Thread

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •