Lay the cutting template over the bezel.
Make your marks.
Now cut. Dremel works best.
Place the new faceplate on the bezel.
Now trim the plastic above the radio opening. Depending on your radio depth, you may also need to cut off the metal bracket circled in red. Sawzall works best here just move your wires out of the way.
And if your radio is deep like mine, the bottom bracket will need to go too.
Now there is so much room for activites! Excuse my mess. I have 2 amps in my system.
Finished product.
You may need to take the bezel on and off several times to get your radio in the right position.
Link to kit: http://www.metraonline.com/part/95-6547B