Does anybody on the sight know if the rear block crank trigger can be put on the R-3 block ?? Thanks.
Does anybody on the sight know if the rear block crank trigger can be put on the R-3 block ?? Thanks.
You mean the factory crank sensor? I so some R3 blocks have the crank sensor boss and you can use the factory crank sensor.
This signature has been deleted thanks to photobucket!
Yes this R-3 block don't have the boss. Thanks for the reply.
How far can yours be bored ?? Still getting info on this block. Thanks again.
Why not just run a trigger on the balancer.
4.220"
Why are you wanting to run the factory crank sensor on an R3 block? if you are building an engine with the power level for a need of the R3 block, I wouldn't run the crappy JTEC EFI.
My R3 block is 4.000" rough bore, 9.560" (tall deck) Siamese water block with standard cam bearing tunnel and 59* lifter bore angle.
This signature has been deleted thanks to photobucket!
Just found out it's a 340 wet block r-3 block,,already bored to 4.080 max bore and has a few scratches that'll not clean up till 4.085 area ,, block is done.. Thanks for the help-advice..