-
Senior Member
Status
- Offline
4 bbl. 1200 cfm. How to.
Where can i get pig tails to install a 1200 cfm.speedmaster 4 bbl. on my 408 ? i think the sensors are iac 95 impala and tps 89 mustang. i know i need a 2 in. spacer. i have the 4 bbl. intake air gap already. Thanks.
-
Senior Member
Status
- Offline
Did you check out diyautotune?
or rock auto?
-
Senior Member
Status
- Offline
Yes rock auto,, i was looking for direct plug in wire pig tails to the dakota loom, or exact wire schematic from sensors to our dakota wire plug ins..
saw some on our site but nobody replied..
is the 4 bbl. 1200 cfm. worth the work over a big 2 bbl.980 cfm. ???
-
Senior Member
Status
- Offline
Ah gotcha.
Doubt youll need the 1200. 980 can support a lot of power.
-
Senior Member
Status
- Offline
Not sure how accurate the 980 cfm. figures are,,plus with 4 bbl. there's better air distribution,,but not sure if much more hp. ,, i think would help on top end and acceleration.. Need somebody to chime in who has done the swap for their input..
Posting Permissions
- You may post new threads
- You may post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules