+ Reply to Thread
Results 1 to 4 of 4

Thread: Window regulator craziness

  1. #1
    Senior Member

    Status
    Offline
    Join Date
    Sep 2014
    Location
    Los Angeles
    Posts
    426

    Default Window regulator craziness

    Guys, need bit of help. I have an '00 quad cab, need to replace right rear regulator.

    Bought two so far, used OEM off ebay, but neither of them fit. Different bolt pattern.

    What the heck is the deal here? Did the 2000's use ones from the earlier durangos? Can I just redrill the holes for the new bolt pattern and use it? Its just the motor that mounts differently, the window slide is the same.

    This was a simple thing that turned into a real pain....

    Thanks folks

  2. #2


    99dart's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Feb 2008
    Location
    Washington...the hot side!
    Posts
    3,886

    Default

    Will these picks on Rockauto help you identify a difference? https://www.rockauto.com/en/catalog/...assembly,15596
    99 DA CC R/T
    13.97@100 w/modded kegger & ported TB
    12.96 @103
    10:8-1 .30 over forged bottom end
    R/T ported heads
    Detroit locker 4:56 gears
    Built 46RE MSaine 3500 stall Ultra Billet
    http://imgur.com/a/lOVuZ

  3. #3
    Senior Member

    Status
    Offline
    Join Date
    Sep 2014
    Location
    Los Angeles
    Posts
    426

    Default

    Most of those are fronts.

    Well, it seems like the 2000 quad cab uses 98-00 durango rear regulator. mid '00 they went to a different design.

    GO FIGURE. Sucks for me..

    Thanks!

  4. #4
    ZenDak's Avatar
    -Zen-

    Status
    Offline
    Join Date
    Apr 2015
    Location
    Coconut Creek FL
    Posts
    243

    Default

    Don't feel bad, I have a Durango window regulator I mistakenly bought for my '00 reg cab collecting dust in my garage too.

+ Reply to Thread

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •