+ Reply to Thread
Results 1 to 3 of 3

Thread: Any tricks to removing stuck on hub bearing off of spindle?

  1. #1
    wh23g3g's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Jun 2015
    Location
    Snellville, GA
    Posts
    484

    Default Any tricks to removing stuck on hub bearing off of spindle?

    I've got the 03-04 brake upgrade spindles now. I got one with the bearing off and the other the bearing is stuck on there. I know last time I changed the stock one on my 99 I was able to pull it with a 3 jaw puller. It won't do anything on this 03-04 bearing. All it did was just make a dent in the center of the hub mount. I tried spray it with penetrating oil overnight but still no luck. The hub moves around the bearing, so the bearing is stuck on there. Any other suggestions? I got them off of ebay so I didn't know it was going to have the bearing on one. I guess the salvage yard got one off easy and then couldn't get the other one off, since the hub nut is loose. I'm guessing they attempted to remove it but couldn't.

  2. #2

    Default

    HEAT and a BIG hammer!!

  3. #3


    99dart's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Feb 2008
    Location
    Washington...the hot side!
    Posts
    3,886

    Default

    What he said!!!^^^
    99 DA CC R/T
    13.97@100 w/modded kegger & ported TB
    12.96 @103
    10:8-1 .30 over forged bottom end
    R/T ported heads
    Detroit locker 4:56 gears
    Built 46RE MSaine 3500 stall Ultra Billet
    http://imgur.com/a/lOVuZ

+ Reply to Thread

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •