+ Reply to Thread
Results 1 to 2 of 2

Thread: Missing/broken ignition cable/wire separator

  1. #1
    Junior Member

    Status
    Offline
    Join Date
    Jun 2016
    Location
    San Diego, Ca
    Posts
    12

    Default Missing/broken ignition cable/wire separator

    I’m having a hell of a time replacing the broken and missing spark plug wire separators for my 5.9. Any suggestions on where to find ones would be appreciated. I went to rock auto and they don’t have them. Did a search, and cannot find a place they would be. These are the parts that snap onto the riser bolts from the valve covers. Even went to dodge and they say they’re discontinued.
    Thanks
    Brandon

  2. #2


    99dart's Avatar
    Senior Member

    Status
    Offline
    Join Date
    Feb 2008
    Location
    Washington...the hot side!
    Posts
    3,886

    Default

    You will probably have to scrounge the wrecking yards. The first time I tried removing mine they broke. I switched to these, but then didn't like how hard it was to hold the wire seperator while trying to tighten the valve cover bolts. I ended up using them without the hold down after a couple years.
    https://www.ebay.com/itm/Taylor-4250...5ZMafJ&vxp=mtr
    99 DA CC R/T
    13.97@100 w/modded kegger & ported TB
    12.96 @103
    10:8-1 .30 over forged bottom end
    R/T ported heads
    Detroit locker 4:56 gears
    Built 46RE MSaine 3500 stall Ultra Billet
    http://imgur.com/a/lOVuZ

+ Reply to Thread

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •