Sawzall?
Sawzall?
Jim
RaceMagnum
My A/C is loooong gone
Jim
RaceMagnum
Custom AC lines. Would the cruise cable work if the servo was mounted on the drivers side of the engine.
Last edited by 9t9-5.2; 11-15-2017 at 11:04 AM.
"Excuse me if I have some place in my mind, where I go time to time"
My truck is an 03, and I ran into those same issues. The dipstick, I just bent the tube to fit, but it is still difficult getting the dipstick back in the tube, but just takes patience. I just grabbed the AC lines and bent them out of the way to clear by a little. When I still had the cruise control, I moved it to one of the bolts that holds the radiator support, bent the bracket slightly, and zip tied the cable to the AC lines I bent out of the way. However, since you are front mounting your intercooler, this probably will not fix your issues.
Are you trying to use the 00-03 condenser, or are you using the 98-99 condenser?
2012 Grand Cherokee Limited Wife's car - 4X4, Hemi
2003 Dakota RT RC, Hughes intake and throttle body, D1SC Procharger, 5-speed
2009 Challenger RT, 6-speed, sportlines, x-pipe, Dynatech mufflers.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Excuse the newb question but I am assuming you decided to put a procharger on it instead of rebuilding the motor with better heads/cam/increase compression/stroke the motor is because the procharger will provide more power and have less cost than trying to build the motor?
Also if I am reading correctly everything you are doing the inside of the motor is not being touched?
Looking forward to dyno results.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
2012 Grand Cherokee Limited Wife's car - 4X4, Hemi
2003 Dakota RT RC, Hughes intake and throttle body, D1SC Procharger, 5-speed
2009 Challenger RT, 6-speed, sportlines, x-pipe, Dynatech mufflers.
It's ready......
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Mods - TB Spacer, Short Throw Dipstick, Performance Auto Zone Intake "0.30 over bore", R/T Cam, Performance Chip, Radiator Delete
Rev limiter? that's what valve springs are for!
You tease.
We need details.
Project Maverick. I feel the need, the need for speed
This thing has been kicking my ass.
Got 2 bad map sensors from 2 different places. Ended up having to use my backup GM 2 bar.
So far have just been driving it, have brought it up to 6.5 psi part throttle, the truck really runs great.
Having an intermittent no spark issue, gonna see about replacing crank sensor and see if that takes care of it.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
2012 Grand Cherokee Limited Wife's car - 4X4, Hemi
2003 Dakota RT RC, Hughes intake and throttle body, D1SC Procharger, 5-speed
2009 Challenger RT, 6-speed, sportlines, x-pipe, Dynatech mufflers.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Update.
Fell asleep at the wheel, went off the road with it. Oops. Thankfully a tire was the only damage.
Adding a bunch of upgrades, fixing the belt slip, then Dyno time at last.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Damn, that sucks...glad you're OK.
408, HiPoTek, FRP Tuning, Martin Saine 46re12.33 @ 1102018 Renegade Raceway Summit Series Sportsman Champion
Just glad I didn't hit anyone or anything else.
List of stuff that we are going to be wrapping up in next few weeks:
Water pump (maintenance)
Hipotek 46re crossmember
X brace (found an old Kenny Brown unit)
Calvert 90/10 shocks
New tires
Hipotek torque strap.
Re-index Procharger tensioner
Install custom supercharger brace to eliminate bracket flex
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Glad you're OK, Ryan!
99 DA CC R/T
13.97@100 w/modded kegger & ported TB
12.96 @103
10:8-1 .30 over forged bottom end
R/T ported heads
Detroit locker 4:56 gears
Built 46RE MSaine 3500 stall Ultra Billet
http://imgur.com/a/lOVuZ
Hah. And I was once worried about you making a hole in the ground flying a Piper. You're like the rest of us getting in trouble on the ground. I once fell asleep driving my 428 Mustang. It maneuvered itself right around a gentle curve in the hwy. Traveled about a mile. Woke up at the next exit wondering how I missed my own. No more doubles for you.