Guys who have been running a stock bottom end with boost have you had to open up the ring gap? I've been told by a local after 10 psi there's a high risk of butting the rings because the temps get too high. Anyone have some experience with this?
Guys who have been running a stock bottom end with boost have you had to open up the ring gap? I've been told by a local after 10 psi there's a high risk of butting the rings because the temps get too high. Anyone have some experience with this?
Mods - TB Spacer, Short Throw Dipstick, Performance Auto Zone Intake "0.30 over bore", R/T Cam, Performance Chip, Radiator Delete
Rev limiter? that's what valve springs are for!
here's a reference chart from Total Seal ---> http://www.totalseal.com/pdf/GAPCHART.pdf
If you haven't lived for something, you'll die for nothing.
No. Seriously, never have I ever had a problem keeping a stock bottom end together. Keep the timing reasonable , DONT try to lean on it on pump fuel , cool plugs and you'll be fine.
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Mods - TB Spacer, Short Throw Dipstick, Performance Auto Zone Intake "0.30 over bore", R/T Cam, Performance Chip, Radiator Delete
Rev limiter? that's what valve springs are for!
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!
Mods - TB Spacer, Short Throw Dipstick, Performance Auto Zone Intake "0.30 over bore", R/T Cam, Performance Chip, Radiator Delete
Rev limiter? that's what valve springs are for!
Mods - TB Spacer, Short Throw Dipstick, Performance Auto Zone Intake "0.30 over bore", R/T Cam, Performance Chip, Radiator Delete
Rev limiter? that's what valve springs are for!
RYAN/TUNED
Got questions?!? Get the answers ->>> http://www.dakotart.com/forum/showth...estions-thread
For fastest response please text or email at ryan@frptuning.com ,please no PM's!!!