So ive begun my winter project of rehashing my 360 and though i would start up a forum for everyone to follow while they were bored at work . So a little about the engine:

Bottom End:
Forged mopar crank with scat forged i beams that are. Keith black flat tops.

Top end: (in the process)
Hughes 230/234 .565 .571 cam
Hughes eq heads with 2.02 1.61 stainless valves with bronze valve guides
Hughes roller rocker arms at 1.6 ratio.
Pushrods are To Be Determined, i know im going hardened but dont know length and width yet.
28lb injectors and billet rails with the crossover.
52 or 53mm throttle body and Hughes/Edelbrock air gap.

There is probably more that im forgetting but ill update as i go.
So im going to be spraying this motor with 150 shot and im at 6200 feet. The truck is a 5 speed and it has 3.92 rear end gears. Im saying this because who ever can guess closest to horsepower on a chassis dyno with get a 10 gift on pay-pal. LET THE BETTING BEGIN. (this is just a friendly fun thing i though would be cool to do) Illl take bet up until the day i dyno it.)