ive had a few people ask me for more pics so i took some pics and a video to give you an idea of what they look like. seats were out of an 08 srt8 300.
http://i405.photobucket.com/albums/p...s/SSPX0239.jpg
all i did in the front was weld some l bracket to the bottom of the seat rail
http://i405.photobucket.com/albums/p...s/SSPX0267.jpg
i then had to buy a passenger side seat switch and hard wire the seat motors
http://i405.photobucket.com/albums/p...s/SSPX0274.jpg
and cut out the trim piece so the switch could fit being thats its reversed on the driver side. measure twice and cut once. i must have forgot that haha
http://i405.photobucket.com/albums/p...s/SSPX0275.jpg
this has to be done because the driver seat send signal to a canbus module which then sends signal to the motors through another module thats under the seat
in the backl i just drilled holes in the floor and used 1/4'' plating for support for the bolts on the outside. inside bolts went through the same bracket as the center console. i figured that was enough support
inside bolt
http://i405.photobucket.com/albums/p...s/SSPX0269.jpg
ouside bolt
http://i405.photobucket.com/albums/p...s/SSPX0270.jpg
plates i cut and painted
http://i405.photobucket.com/albums/p...s/SSPX0271.jpg
end result
http://i405.photobucket.com/albums/p...s/IMAG0015.jpg
http://i405.photobucket.com/albums/p...s/IMAG0017.jpg
http://i405.photobucket.com/albums/p...s/IMAG0016.jpg
a quick walk around video with more views of the seats
http://s405.photobucket.com/albums/p...=VIDEO0006.mp4