Search:

Type: Posts; User: wedged

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds; generated 42 minute(s) ago.

  1. Thread: SHOCkS

    by wedged
    Replies
    6
    Views
    4,347

    maybe the engine/trans offset is countered with...

    maybe the engine/trans offset is countered with the weight of the driver...and the fuel tank being on the driver's side too. The different rates on the 2 springs checked is likely just a QC issue.
  2. Replies
    27
    Views
    3,484

    double check the extended and collapsed length if...

    double check the extended and collapsed length if lower than a stock R/T. also check the bushing sizes. this is results from a quick search on bilstein's website.
    ...
  3. Replies
    27
    Views
    3,484

    no, it would not. the only info missing is the...

    no, it would not. the only info missing is the rear leaf rate.
  4. Replies
    27
    Views
    3,484

    Hotchkis would be out their minds to revive this...

    Hotchkis would be out their minds to revive this kit unless they had a pre-paid order large enough to make it worth while.

    that being said I'll put on the Captain Obvious cape... i think it would...
  5. Thread: HP Tuners

    by wedged
    Replies
    18
    Views
    2,625

    something seems fishy... the HP Tuner website...

    something seems fishy... the HP Tuner website indicates that jtec vehicles are supported.
  6. Thread: HP Tuners

    by wedged
    Replies
    18
    Views
    2,625

    that's some stupid shit right there... wow. i was...

    that's some stupid shit right there... wow. i was waiting for the new version.
  7. Replies
    2
    Views
    1,978

    I'd like to know too...

    I'd like to know too...
  8. Replies
    18
    Views
    2,795

    i’m sure you have a DRO…. lol.

    i’m sure you have a DRO…. lol.
  9. Replies
    18
    Views
    2,795

    imagine if people think to search for stuff..... ...

    imagine if people think to search for stuff..... :jester:

    Just need to determine port openings...

    https://www.schoenfeldheaders.com/mopar.html

    ...
  10. Replies
    7
    Views
    1,792

    takes under 5 minutes to pull the pedal &...

    takes under 5 minutes to pull the pedal & shaft... :jester:
  11. Thread: 5 speed swap

    by wedged
    Replies
    3
    Views
    1,209

    I have an AX15 behind a 5.9L with an FRP tune &...

    I have an AX15 behind a 5.9L with an FRP tune & headers in a 98 Dakota. The 97 has all of the parts you need except the flywheel.
  12. Replies
    5
    Views
    1,297

    remove the carpet from the tunnel and take a...

    remove the carpet from the tunnel and take a look. there may be an embossed area where the shifter goes.
  13. Replies
    7
    Views
    1,792

    you don't need the bracket unless the existing...

    you don't need the bracket unless the existing one is broken or missing. They are the same for manual and auto. You only need to swap the shaft and install the pedal.
  14. Replies
    17
    Views
    3,739

    the clutch pedal and pedal shaft are the same...

    the clutch pedal and pedal shaft are the same from 1997-2004... and even newer. I stopped checking part numbers at 2007.
    The shaft and bushings are avalable new. You do not need the pedal bracket,...
  15. Replies
    57
    Views
    40,612

    old news.... ...

    old news....

    http://www.dakotart.com/forum/showthread.php?39133-Looks-Like-HPTuners-Finally-Supports-These-Vehicles&highlight=hp+tuners
  16. Replies
    35
    Views
    5,523

    looks like it burned from laying against a header...

    looks like it burned from laying against a header tube.
  17. Replies
    35
    Views
    5,523

    if you are 100% sure that the firing order is...

    if you are 100% sure that the firing order is correct, start the engine and let it idle to warm up. using a spray bottle of water, spray each header tube and verify no sizzle on the 5 & 8 tubes and...
  18. Thread: R/T Wanna be

    by wedged
    Replies
    7
    Views
    4,089

    ...except installing the clutch pedal only...

    ...except installing the clutch pedal only involves removing a C clip, replacing the pivot pin with the manual specific one and sliding it through a clutch pedal. The pedal bracket is identical to an...
  19. Replies
    37
    Views
    4,667

    I agree with this post. Until the exhaust leak is...

    I agree with this post. Until the exhaust leak is fixed and the tune is corrected you cannot make any judgement on how much power it is making or will make. Fix the known problems and then see where...
  20. Thread: 00' Regular Cab

    by wedged
    Replies
    31
    Views
    5,685

    it's got nothing to do with feelings. I was only...

    it's got nothing to do with feelings. I was only wondering how much you were able to negotiate the price down and hoping you got a better deal.
  21. Thread: 00' Regular Cab

    by wedged
    Replies
    31
    Views
    5,685

    The 5.7 hemi that is going into one of my Dakotas...

    The 5.7 hemi that is going into one of my Dakotas came from a Durango that spent most of it's life in your area, so I've seen how bad things can get. I got it for about $450, pulled the engine, and...
  22. Thread: 00' Regular Cab

    by wedged
    Replies
    31
    Views
    5,685

    You picked that up in Fort Myers, correct ? I...

    You picked that up in Fort Myers, correct ? I believe the asking price was $5,500 ? My buddy and I were thinking about checking it out, but the price was too high for the mileage and condition. I'm...
  23. Thread: Got it running!

    by wedged
    Replies
    23
    Views
    5,259

    if you do some research on X pipes and how they...

    if you do some research on X pipes and how they are supposed to work, you'll discover that this is really not an X pipe.
  24. Replies
    12
    Views
    3,391

    better idea, modify a torker 2 by adding injector...

    better idea, modify a torker 2 by adding injector bungs and changing the bolt angle. ... but then there's still the issue of mounting the ac.
  25. Replies
    20
    Views
    6,765

    :jester: Just watch his vidoes, and then do NOT...

    :jester: Just watch his vidoes, and then do NOT do what he does and you'll be fine !

    I'm in the process of gathering all of the parts needed to do a swap using a 5.7 and a NV3500 . I'm in florida...
Results 1 to 25 of 193
Page 1 of 8 1 2 3 4