Ive dealt with richard at hipotek and he is top notch. Ive dealt with indy and it there was a little more to be desired. Hughes i know alot of people give them a bad rap but i had them fix and port a...
Type: Posts; User: slvr03dakrt
Ive dealt with richard at hipotek and he is top notch. Ive dealt with indy and it there was a little more to be desired. Hughes i know alot of people give them a bad rap but i had them fix and port a...
Hi powered rifle will take care of that. Cough cough ar 15
I would go bigger on the cam. I built a 408 with a 228/230 cam and it was all done at 5600rpm and had tons of tq. It paired nicely with a 2800 converter and had great street manners and decent mpg.
Damn on track for a 20 yr build
I was fixing to say projected tip and nitrous dont mix.
Ask Dstoots about that.
Nice build, boost is going to wake it up on the bottom end. What heads are you running?
I ground the head down to about half the thickness. I never had any issues
Normally people run a steel top ring for heavy nitrous. But a moly faced ring for ocasional nitrous use is ok the ring gap needs to be opened up a little but should say in the ring pack based on the...
But as far as compressed gasket thickness you will prob need to find something .055 to .060 thick i always like to have right at .040 quench. Hence why i always zero decked my motors and ran a .039...
So you brought the piston up to zero deck verified by the straight edge across the bore. Then set a dail indicator at 0 then contiued to rotate the end and it read .015 past zero. Sounds good to me.
Obama can suck me
Well i blew my shit up once bc i cheaped out on a cast stroker crank. It was only a 5 grand mistake.
Was it a one hit wonder?
Start with a 75 hit and if all goes well jet it up. Read the plugs they will tell the tale also an Afr Guage is good to have.
High 12s or low 12s.
Remove it for sure. When it sits just make sure you put in gear and let it sit for a second before depressing the gas.
It's all about making a few extra dollars.
It ain't doing any good sitting on the kitchen counter. Get to work and get it put on.
Looks good I miss my silver 2003 I had. :dumbass234: should of kept it.
Yea might wanna post basic specs bc I can't see the cam card very good
Yep stock computer with sct custom tune will take you along way. I'd step up to a good set of heads and cam to let that stroker breath. I think the best street setup is a set of blended Eddie heads...
Drill it out completely and helicoil it
For 32k I can make 1000+hp with less headache.
I took it up to the local auto shop with the springs off the truck and walked in the back door with a 10 dolla bill put them on the press and said I need these bushings in here and 3 mins later I...