A carbon fiber covered fiberglass one piece back window plate would suffice. :biggthumpup:
Type: Posts; User: ddrango
A carbon fiber covered fiberglass one piece back window plate would suffice. :biggthumpup:
Get a ScanGauge II
The Dakota R/T is NOT on the list
http://www.gtplanet.net/forum/showthread.php?t=86724
It's a possibility though.
.100%.
Any idea where these valve cover spacers are?? Haven't found them
Here are my fall shots!
Clicky
03/04 front spindles, 03/04 front calipers & rotors (that match the vehicle the spindles came off of), die grinder to grind down the end of your brake line mount.
Did it a few times on people's...
Thanks you Dave :biggthumpup: Hope all is well with you
I guess I'll think about throwing my M1 on this motor in the spring...it's been sitting in my room for two years now.
It's a 4bbl.
True, but the M1 is for my 426.
Hmm...I think I'm going to try 89 just for the heck of it. I don't really drive the truck much anymore, but I'll give it a shot. I'm going to overhaul that...
Definitely burning oil...got codes for pre cat sensors, so in the spring I'm ripping the barrel off and cleaning up. Damn belly pan!
Ok, it's definitely the oil then. My manifold's belly pan gasket has been horribly blown for a little over a year now. It's so bad I would most definitely gain a couple of tenths fixing it.
Might...
Really? You think I should use the 89 tune?
Very limited on time these past few weeks, my fathers ill again and is pulling through yet again. He goes into surgery in the morning.
Anyway, this past weekend I managed to get to the track for...
Well Hotchkis lists that the leaf springs with the four plates will drop a R/T 2 1/4" out back, and without the plates it will drop a R/T 1 1/4" out back. So I used no plates (1 1/4") and used WC...
My truck seems to have more rear bite than front bite now with 03' R/T rear brakes and 02' front brakes.
When my bud did the brakes he clamped the single main line coming to the distribution block...
I had 3" blocks on R/t leafs, and went to Hotchkis leafs (no plates or anything) with the 2" rear hangers, and I'm almost 2" higher than I used to be! According to Hotchkis manual on the leaf...
For some odd reason they appeared to not give me any drop on my truck, I can't figure it out. I'm not sure if I'm going to put 1" blocks or the front hangers from WC that I have on. If anything, if...
LoL, really??
My bro has the whole kit and he cut his own exhaust holes into it, if you're interested I'll talk to him about it.
owned
Ok sir, I'm sure they're 18", I mean he can't be wrong it's his ad.
Too bad those are 17"
You got that right Chas! The beds of EVERY Dakota ever made to this day are identical. Only difference with the older ones (Gen1 &2) is that they're narrower. Good find though! How you been? Hows...