I don't come very often ,could you contact me at rohr911@gmail.com
To purchase these .
Thanks Larry.
Type: Posts; User: DodgeSqD
I don't come very often ,could you contact me at rohr911@gmail.com
To purchase these .
Thanks Larry.
I'm getting ready to order some more Candence QRS6.5 coaxial speakers to go allong with these Candence CMVs 6" components with a Thunderfourm sub box . I'll need 2 amps to run this set up . A 300 .2...
Nice work
Well my procedure doesn't cost anything .
You may need to reset the stepper motor count . " the IAC is what I'm talking about .
Unplug the IAC . then plug the vent for the IAC . Then start the engine and adjust the idle set screw to 650...
I have one of these transmissions. Still in its shipping crate.
When my 05 MSaine goes this will get its VB. then installed.
Mouth breather here cocksucker. LoL
Not on here much, 3-4 times a month
Nice truck Dead fish. LOL
Finally . It's in, but the flange on the right down tube needs to be clocked to install the exhaust .
Larry
Welcome
Are you near Red Bluff Ca .its a stop I make every few months .
On your issue with the lever against the fuelrail.
Cut a 1/8th thick aluminum plate to fit under your throttle body
Use a gasket for a template.
Never mind the what's this and what's that .a solid lifter with a pushrod checking tool and the correct roller tip pattern accross the valve tip ,is all that matters . When ever anything is changed...
First thing to check for when doing electical on an older vehicle is that all grounds are clean and tight . If in droubt add a ground strap. If the switch is getting hot , the new bulbs my draw too...
You need to make your lifter solid . Remove the internals of your lifter and make a shim out of a bolt and nut , I used a 5/16 x 1" hex bolt from my header . Adjust the nut so when you drop the cup...
I don't know any other way , sorry as a last resort ,pull the interior from where the door meets the strike bar , drill out the mounting bolts
I 've been keeping up with your build for some time . Congrats on your championship . These heads flow enough for the build I'm finishing ,and I did try a set of Jesel rockers on this motor they...
If it was me , I would pull the door panel off the passenger side and and close the latch with the door open and figure out how to open it from inside the door its self..
Yes, the heads were worked over by the Fastman's guy back in 05 ,and yea they have taller height valves .My shimms are .250 thousands tall .Now I can order my pushrods. And when I get back in a...
Got my block back from the machine shop . Spent the day dry fitting the motor , and now ill be able to order the pushrods.
Some engine pics
These pics were taken at Rich's house when he showed me the truck in Ohio . Included is a cool rendention of Fred and Wilma
How close are you to Red Bluff CA .
Ill be there on sunday .
How close are you to Red Bluff CA .
Let me try this