• Recent Articles

  • Latest Classifieds

  • Recent Forum Posts

    SynRG

    '01+ Double din install with new Metra Kit

    Here's what I had before:


    I got over waiting for the screen to flip out every time I got in and started the truck.

    SynRG Today, 01:01 AM Go to last post
    krs1r/t

    CAMS - for 4.250 stroker

    Remember
    Higher and sharper the cam lobe
    Higher spring pressure to keep lifters
    On the lobe.
    More adjusting valves, rougher

    krs1r/t Yesterday, 11:35 PM Go to last post
    99lowdakota

    CAMS - for 4.250 stroker

    If iirc I think hughes gets all its cores from Comp Cams or something like that. Just give Comp Cams a call and tell them what your trying to do. because

    99lowdakota Yesterday, 10:05 PM Go to last post
    arro222

    CAMS - for 4.250 stroker

    Depends what is being meant by "aggressive lobes". If we're talking ramp profiles and not lifts, Comp will design any ramp speed (as well as

    arro222 Yesterday, 03:30 PM Go to last post
    kota360

    CAMS - for 4.250 stroker

    Years ago I bought a cam from Hughes and was charged for a "new" cam. When I had issues with the motor, I took the cam out and sent it to another

    kota360 Yesterday, 11:18 AM Go to last post
  • Recent Activity Widget

    packard1

    R-3 block wanted

    Thread Starter: packard1

    I'm looking for an R-3 block #P4876793AC , is the best I'm told ? Where's a good place to find one if any ??:goodluck: cheaper than Ritter block...

    Last Post By: packard1 Yesterday, 03:44 AM Go to last post
    SynRG

    '01+ Double din install with new Metra Kit

    Thread Starter: SynRG

    Lay the cutting template over the bezel. Make your marks. Now cut. Dremel works best. Place the new faceplate on the bezel.

    Last Post By: SynRG Today, 01:01 AM Go to last post
    packard1

    CAMS - for 4.250 stroker

    Thread Starter: packard1

    How do Hughes cams compare to comp. cams ?? note- Hughes does mark cams in book if new core. all there bigger cams are new cores.. . Heard Hughes...

    Last Post By: krs1r/t Yesterday, 11:35 PM Go to last post