• Recent Articles

  • Poll Widget

    Which finish for my R/T 20's? (Votes: 31)

    1. Black Chrome (Votes: 16)

    2. PC Gunmetal grey (Votes: 4)

    3. PC OEM silver (Votes: 3)

    4. PC Black (Votes: 1)

    5. PC Charcoal grey (Votes: 2)

    6. Other (Votes: 5)

  • Latest Classifieds

  • Recent Forum Posts


    Fully Porting Kegger

    I am a Hughes dealer. I have been putting peoples name on a list, and I will let them know when the Hughes Airgap becomes available again. (Hughes has

    98Dak408 Today, 02:44 PM Go to last post

    Fully Porting Kegger

    I suppose you could cut up the kegger in order to fully port it and weld it all back together. But then the rpm would have to increase in order to maintain

    98Dak408 Today, 02:38 PM Go to last post

    3-barrel throttle body

    DOES ANYBODY STILL MAKE the 3-barrel throttle body?

    packard1 Today, 12:25 PM Go to last post
    Red barchetta

    Fully Porting Kegger

    The results aren’t bad for 100 $ . Takes about 15 hrs to do th whole thing. Including welding plates in and opening top. Might want to get a junkyard

    Red barchetta Today, 03:53 AM Go to last post
    musky mike

    5 speed swap

    I have a 2001 R/T and want to do a 5 speed swap. I found a cheap 1997, 3.9L, 5 speed truck. I could pull everything out that truck except for the fly

    musky mike Today, 01:08 AM Go to last post
  • Recent Activity Widget


    Solar Yellow 99 CC

    Thread Starter: Stormbride1

    Hey guys, Ive just recently found this site and forum. Ive owned a solar yellow 99 Dakota R/T CC for the last few years and have done a ton of work...

    Last Post By: musky mike Today, 12:28 AM Go to last post

    Fully Porting Kegger

    Thread Starter: skeptic68w

    Hello everyone, I am new to the board(long time lurker). I do not actually have a Dakota, but rather an 01 Ram that I am building an engine for at...

    Last Post By: 98Dak408 Today, 02:44 PM Go to last post