PDA

View Full Version : how do you mount paxton crank pulley on a 2000 r/t



chris4341
01-06-2010, 01:15 AM
Got the stock crank pulley and damper off, Now how do mount the Paxton pulley?

SB440R/T
01-06-2010, 02:18 AM
Truthfully, I would have the spacer machined to match the 6 bolt Damper. So you need two piece, 97-99 damper and pulley. or and aftermarket damper and 97-99 pulley. The reason for this? The stock paxton set up comes with everything but you have to use 3 tiny pins to line everything up and then the crank bolt. I did not trust that. In fact mine looked loose and looked like it twisted after I took it off.

SB440R/T
01-06-2010, 02:24 AM
Got the stock crank pulley and damper off, Now how do mount the Paxton pulley?

Here are some pictures

http://i35.photobucket.com/albums/d197/Davidsalazar03/CIMG2112.jpg

http://i35.photobucket.com/albums/d197/Davidsalazar03/CIMG2113.jpg

http://i35.photobucket.com/albums/d197/Davidsalazar03/CIMG2114.jpg

You can see where the pins were eating the spacer. And you can also see what I mean about machining to match the 6 bolt pattern.

I just went with a bigger aftermarket pulley, kind of pricey. I got lucky and got it off of a member on here for cheap.