View Full Version : Paxton Stock Crank Size?
SB440R/T
09-17-2009, 08:37 PM
I searched, but I guess I suck. I know I have seen it.
Right now I am getting 13 psi with the stock pullies shifting at 6000 rpm.
I got Kevins old blower pulley. I think its going to put it at like 18-19 psi. Trying to find a good middle ground of about 14.5 psi. The new blower pulley is 8.5 in vs the stock size. What does everyone think?
mtlcafan79
09-18-2009, 01:12 AM
Why not change the blower pulley instead? You can get those in 1/8" or 1/10" increments I believe.
SB440R/T
09-18-2009, 01:17 AM
Cause the shit that was on there was crap. This will be a better more reliable set up. Plus less worry about belt slip.
WhiteRT
09-18-2009, 03:23 AM
Cause the shit that was on there was crap. This will be a better more reliable set up. Plus less worry about belt slip.
PM me for a little secret I was recommended by a machinist friend - you stole my paxton, never got to try it :)
I think it might work on the belt slip front :)
Todd
Sick 660r
09-18-2009, 03:27 AM
PM me for a little secret I was recommended by a machinist friend - you stole my paxton, never got to try it :)
I think it might work on the belt slip front :)
Todd
how about you pm me the same message :D
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.