PDA

View Full Version : Paxton Stock Crank Size?



SB440R/T
09-17-2009, 08:37 PM
I searched, but I guess I suck. I know I have seen it.

Right now I am getting 13 psi with the stock pullies shifting at 6000 rpm.

I got Kevins old blower pulley. I think its going to put it at like 18-19 psi. Trying to find a good middle ground of about 14.5 psi. The new blower pulley is 8.5 in vs the stock size. What does everyone think?

mtlcafan79
09-18-2009, 01:12 AM
Why not change the blower pulley instead? You can get those in 1/8" or 1/10" increments I believe.

SB440R/T
09-18-2009, 01:17 AM
Cause the shit that was on there was crap. This will be a better more reliable set up. Plus less worry about belt slip.

WhiteRT
09-18-2009, 03:23 AM
Cause the shit that was on there was crap. This will be a better more reliable set up. Plus less worry about belt slip.

PM me for a little secret I was recommended by a machinist friend - you stole my paxton, never got to try it :)

I think it might work on the belt slip front :)

Todd

Sick 660r
09-18-2009, 03:27 AM
PM me for a little secret I was recommended by a machinist friend - you stole my paxton, never got to try it :)

I think it might work on the belt slip front :)

Todd

how about you pm me the same message :D