where to find superchargers

[dakotart360]

i am having absolutely no luck finding supercharger kits. just looking for a paxton kit or something thats good for no belt slipping and doesnt take alot of mods after u get it just the head gasket, anyone have any ideas where to get 1 for a good price for a 2003 5.9 dakota r/t flowmaster and airaid intake other then that stock

[GoFastGray]

Just keep an eye out on ebay and here in the for sale section.
I might pick up another Vortech kit to re-sell shortly.

Most kits your going to need a lot of supporting mods.

I just installed a Vortech...other options were;
2bar map sensor $70
Meth kit to keep heat soak to minimum $400
42# injectors $400
SCT $400
LM-2 data recorder to tune w/sct $400
fuel pressure gauge $200
boost gauge $80
A/F gauge $100
custom dash pod for gauges $200
felpro head gaskets $75
manifold gasket $45
crank breather $20
oil and extra bottles to flush valley $80
upgraded air hat $200 (optional)
powdercoat parts $200 (optional)
also got extra bolts, fluids, tools, silicon adapter/stainless straps, etc that I can't remember.

Now that the blower is done...next comes cam, bigger manifold, upgrade heads and port, timing chain, etc...never ends

[dakfink]

keep it around 8-12 psi and you should be good for no belt slip.

Most of us that had belt slip was because we were pushing for 14-15psi or more.

There are a few that have done cog drives BUT that is a real PITA and expensive.

KRC and R/Tmods.com both have Vortech kits available if your not brand picky.

[Pete102580]

Just keep an eye out on ebay and here in the
custom dash pod for gauges $200


wtf? one of rob's pieces?

[Intense RT]

That or call PIE and get a damn turbo. May as well. Beat the hell out of a stock bottom end. I figure if a Grand National can do it....

And you can use the same kit later on a modded long block if you want.

[GoFastGray]

wtf? one of rob's pieces?

Yep :rockwoot:

[ADakotaRTGuy]

i am having absolutely no luck finding supercharger kits. just looking for a paxton kit or something thats good for no belt slipping and doesnt take alot of mods after u get it just the head gasket, anyone have any ideas where to get 1 for a good price for a 2003 5.9 dakota r/t flowmaster and airaid intake other then that stock

How much you willing to spend on a Paxton Head unit with custom air intake, and bracket. Head Unit and Bracket are polished. Would also come with a 16lb main pulley.