Under the Knife

[Lederip]

Truck when in for its makeover today. New rear end (Strange 9") - new ladder bar setup - 35 spline Aftermarket axles - Wilwood Rear disk Brakes - Drive shaft - Roll Bar. Thousands of dollars and not one bit faster:mods: I guess it was time to do it.

Also doing a couple go fast mods - Intercooler - Front skinnys - Converter

Ken

[BTLFED R/T]

Truck when in for its makeover today. New rear end (Strange 9") - new ladder bar setup - 35 spline Aftermarket axles - Wilwood Rear disk Brakes - Drive shaft - Roll Bar. Thousands of dollars and not one bit faster:mods: I guess it was time to do it.

Also doing a couple go fast mods - Intercooler - Front skinnys - Converter

Ken

That suspension setup will prolly make it hook better, therefore making it faster! :biggthumpup:

[slvr03dakrt]

sounds like its going to be a pretty sick truck. Is it still streetable.

[bad360rt]

Hey Ken, were you still on a 9.25 rear with your other ladder bar setup?

[Lederip]

It has very good street maners. Going to be different with the spool.

[Lederip]

Hey Ken, were you still on a 9.25 rear with your other ladder bar setup?

Yep, I was just going to do C-clip eliminators and an aftermarket axle on the 9.25.

After thinking about it, I went with the 9". Want do do everything once this time. Drive shaft--Brakes--Hardened Yoke--U Joints-- etc.

I have a complete 9.25 that I think Shane is going to buy for his project. Detroit locker, 4:56 gears, Ladder Bar brackets, Panhard bar, Coil over brackets all set up and ready to go. Around 2000 easy miles on everything :jester:
Ken

[548ciDakota]

Ya never shot me a price on the 9.25 Ken. Shoot me an email so that I can check with my wife:jerkit: on my build budget. shane@madrt.com

[Rick Adams]

It has very good street maners. Going to be different with the spool.

HA! I can see the future "for sale" ad : Mild mannered Dakota R/T, owned by a little old man only driven to the track on Sundays..... :woot::drive::jester: