View Full Version : Door panel mess up
Sixfootface
06-10-2009, 07:02 AM
Wanted to redo the fabric on it and I thought there were clips. Obviously not. So where do I get another door panel?:laughat:
http://i520.photobucket.com/albums/w329/sixfootface/2002DodgeDakota59022-1.jpg
http://i520.photobucket.com/albums/w329/sixfootface/2002DodgeDakota59023-1.jpg
WraithR/T
06-10-2009, 11:19 AM
You're ok, don't worry. Just pick up a pack of short screws that are slightly larger than hole in the plastic cylinders on the back of the fabric panel. Oh, and a set of washers too.
Install your fabric of choice on the panel. Then remove the door panel and attach screws/washers from the backside. Now they are removable whenever you want to make a fabric change.
Sixfootface
06-10-2009, 09:04 PM
You're ok, don't worry. Just pick up a pack of short screws that are slightly larger than hole in the plastic cylinders on the back of the fabric panel. Oh, and a set of washers too.
Install your fabric of choice on the panel. Then remove the door panel and attach screws/washers from the backside. Now they are removable whenever you want to make a fabric change.
Awsome! Thanks for the input. Im guessing I have to rip the passenger side off the same way then?
AmberFireDaK
06-10-2009, 09:10 PM
I wouldn't rip the other one off...... I took mine off by removing the whole panel, turning it over and grinding the plastic rivets down till you can pop the insert out. I used #8 x 1/2" screws and #10 3/16" washers to reattach my inserts. My interior is different tho so they may not be ideal for you
Sixfootface
06-10-2009, 10:41 PM
I wouldn't rip the other one off...... I took mine off by removing the whole panel, turning it over and grinding the plastic rivets down till you can pop the insert out. I used #8 x 1/2" screws and #10 3/16" washers to reattach my inserts. My interior is different tho so they may not be ideal for you
Great info! Your whole page setup is great! Good pics and I like the two tone.
548ciDakota
06-18-2009, 04:36 AM
Awsome! Thanks for the input. Im guessing I have to rip the passenger side off the same way then?
I think Darren might have created a Pdf on doing this for his panels. http://www.sidewindercustoms.com/
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.