M&H Racemasters ?

[G-Man]

I just picked up a set of M&H racemasters 275/50R17 mounted on stock R/T wheels.
My question is what air pressure is recommended for the dragstrip and for the street? I was thinking about 18 or so at the track & maybe 25 on the street, what you think?

[uwntsumrtII]

i raced & drove at full air psi when i had mine. ~32psi. 25psi all around should be good.

[G-Man]

i raced & drove at full air psi when i had mine. ~32psi. 25psi all around should be good.

Thanks for the reply, I looked at your link, what hood is on the R/T now? and where did you get the hood with the old super stock scoop? I really like it.
Gwyn

[bad360rt]

Yup, I drive mine on the street and at the track with 25psi. You can try lower and see if your truck likes it, but 25psi works best for me.

[uwntsumrtII]

Thanks for the reply, I looked at your link, what hood is on the R/T now? and where did you get the hood with the old super stock scoop? I really like it.
Gwyn

right now i have an AAR Cowl hood on it. before i had a 6-Pack scoop molded to the stock hood (functional of course)

[grapejuice1998]

I just picked up a set of M&H racemasters 275/50R17 mounted on stock R/T wheels.
My question is what air pressure is recommended for the dragstrip and for the street? I was thinking about 18 or so at the track & maybe 25 on the street, what you think?

I'm taking that exact setup to the 1/8 mile this saturday. I have run them before and it seems like they were pretty close to the track pressure you listed.

[G-Man]

Thanks for the feedback, the truck they came off ran a 2.0 60' time on the local 1/8 mile, I hope to do a 1.90 maybe leading to about 9.2 et. (Still slow) but getting faster.
Gwyn