SynRG
07-06-2020, 06:21 AM
Lay the cutting template over the bezel.
https://i.imgur.com/GvsjhrI.jpg
Make your marks.
https://i.imgur.com/cN8asVe.jpg
Now cut. Dremel works best.
https://i.imgur.com/iJvPgaT.jpg
Place the new faceplate on the bezel.
https://i.imgur.com/R96WVBw.jpg
Now trim the plastic above the radio opening. Depending on your radio depth, you may also need to cut off the metal bracket circled in red. Sawzall works best here just move your wires out of the way.
https://i.imgur.com/qwuMU3x.jpg
And if your radio is deep like mine, the bottom bracket will need to go too.
https://i.imgur.com/YqYBrL7.jpg
Now there is so much room for activites! Excuse my mess. I have 2 amps in my system.
https://i.imgur.com/9XFmJqC.jpg
Finished product.
https://i.imgur.com/fKsxiem.jpg
You may need to take the bezel on and off several times to get your radio in the right position.
Link to kit: http://www.metraonline.com/part/95-6547B
https://i.imgur.com/GvsjhrI.jpg
Make your marks.
https://i.imgur.com/cN8asVe.jpg
Now cut. Dremel works best.
https://i.imgur.com/iJvPgaT.jpg
Place the new faceplate on the bezel.
https://i.imgur.com/R96WVBw.jpg
Now trim the plastic above the radio opening. Depending on your radio depth, you may also need to cut off the metal bracket circled in red. Sawzall works best here just move your wires out of the way.
https://i.imgur.com/qwuMU3x.jpg
And if your radio is deep like mine, the bottom bracket will need to go too.
https://i.imgur.com/YqYBrL7.jpg
Now there is so much room for activites! Excuse my mess. I have 2 amps in my system.
https://i.imgur.com/9XFmJqC.jpg
Finished product.
https://i.imgur.com/fKsxiem.jpg
You may need to take the bezel on and off several times to get your radio in the right position.
Link to kit: http://www.metraonline.com/part/95-6547B