View Full Version : uneven pressure plate fingers
Sick 660r
06-11-2011, 04:58 PM
I was about to install the motor and trans today and noticed the fingers on the pressure plate are not even. Everything is torqued to 65ft/lb as instructed and I did so in an even manner. Have any of you guys experienced this? I hoping it just needs some use to even out
Rods59rt
06-13-2011, 08:23 PM
I cooked my clutch and one of the adjusting nuts backed off.I couldn't figure out to set the gap.Pulled the clutch and one of the three fingers were lower.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.