PDA

View Full Version : which heads?



fastdodgert
04-18-2008, 03:26 PM
im lookin for set of heads for my truck. heres what i have so far which head would be a good match up? also, what would be a good cam?

-mopar m1
-long tubes
-high flow cats no mufflers
-CIA
-holley 52mm throttle body
-superchips programmed
-150 shot
-full msd

grapejuice1998
04-18-2008, 04:54 PM
I think the best bargain going is the Edelbrock aluminum head. As for a cam, I'd call Comp Cams and ask them about a grind specific to your needs.

razman131
04-18-2008, 06:28 PM
i second the eddy`s... gives ya some expansion room for the future too...

Hugh Jassole
04-18-2008, 06:44 PM
EQ Magnum Heads from Clearwater Cylinder Heads. 2.02/1.65 heads fully assembled with .600 lift springs for under $900. They outflow PORTED 1.92 Magnum R/T heads, untouched out of the box. There's not a better deal out there. Cam, go with the Sausage Cam from socaldakota.com.

fastdodgert
04-18-2008, 08:40 PM
EQ Magnum Heads from Clearwater Cylinder Heads. 2.02/1.65 heads fully assembled with .600 lift springs for under $900. They outflow PORTED 1.92 Magnum R/T heads, untouched out of the box. There's not a better deal out there. Cam, go with the Sausage Cam from socaldakota.com.

you talkin about these?

http://www.cylinder-heads.com/details.cfm?itemid=1705

slvr03dakrt
04-19-2008, 01:03 AM
Those look like just their standard set. I think you have to call them and tell them what your looking for I have seen an add on ebay with stainless valves and the works for 475 a peice sold by clearwater cylinder heads.

360 XRT
04-19-2008, 02:44 AM
There seems to be a bunch of R/T heads for sale lately.Bare castings at mancini racing were under a grand.

fastdodgert
04-19-2008, 05:13 AM
how much of a difference will i notice with some aftermarket heads?

RyanH360
04-19-2008, 06:00 AM
Like your truck just got a boot in the ass.

Addicted2Blue00
04-20-2008, 02:47 AM
i agree about the CCH heads, unless ya got the money for buy some eddys but if not then CCH over the r/t heads, only problem i had was they could have atleast painted the damn things, i got my set for a lil over $900, 2.02 intake 1.65 exhaust SS valves, 5500 springs etc and 5 angle valve job

Hugh Jassole
04-21-2008, 01:37 PM
you talkin about these?

http://www.cylinder-heads.com/details.cfm?itemid=1705


yep, them's be it