should these go in my car or my truck...

[Jontoad]

put these in the truck, or put them in the car and put the SRT seats in the truck?

http://i55.tinypic.com/2vn3syr.jpg

[Five9Dak]

A drivers seat in each.

[blackknight]

They would also look nice in my truck, lol, those r sweet where did you pick those up?how much?

[BryanRT360]

A drivers seat in each.

:biggthumpup::jester:

[Lewd Crude and Tattooed]

I know a guy that runs thoughs in his dakota. Looks good to me. I say run them in the truck.

[Jontoad]

They would also look nice in my truck, lol, those r sweet where did you pick those up?how much?

bought them 5 years ago but they have only been sat in a hand full of times, they look brand new. they were for a 460 powered bronco on 44's that me and my friend built to run at the dunes. it wasn't street legal with 13inches of lift and we hardly ever used it. so my friend sold the truck to build up his new duramax truck and i got the seats back.

they list on corbeau's site for like 250 each plus shipping now a days. not super expensive because they are fixed back seats but they are real nice quality. built out of the same materials as Corbeau's 400 dollar reclining seats.

they are super comfy. way nicer than the cheap racing seats i have in the truck now.

[blackknight]

nice! yea i have some of those summit racing seats, but i think its time to change them or re-upholster them, however you spell it.lol

[Jontoad]

so i just couldn't bring myself to take the SRT seats out of the car. the seats went into the truck today.

taking the ford bronco brackets off and the modded Dakota rails off the old seats.

http://i52.tinypic.com/332z05s.jpg

almost done with the mods to the brackets. still had to grind off the extra on the flat stock since the old seats were way wider than these. i had to drill new holes in the Dakota rails and offset one rail about an inch and a half wider than the seat. each seat is offset towards the door to allow for clearance for the seat belt receiver on the console side. the seat belt receiver was already relocated off the stock rails from the last seat install. but what i had to do was grind it off the rails, drill a hole in the bracket, custom bend the bracket and install it on the rear seat bolt.

http://i53.tinypic.com/30k7wjm.jpg

view into the back window at the back logo on the seat.

http://i53.tinypic.com/34opill.jpg

all done.

http://i56.tinypic.com/nc1t7m.jpg

http://i51.tinypic.com/ng3o9h.jpg

side view of the modded rails.

http://i55.tinypic.com/6nryo9.jpg

[BlackRT]

Looks good!

[Jontoad]

Looks good!

thanks!

it was a great to get to vacuum the hell out of the carpet and get in all the places that you can't with the seat in the way too.