who's using venom injectors

[timmydatoolman]

I am looking at a set of venom 60# injectors here is my problem, according to venoms web page their injectors over 50# are low impedance , but on several sites that sell them the 60's are listed as high impedance.
Is anyone using venom injectors of 50# or greater, and what impedance are they?

[mtlcafan79]

If they are truly low impedence, I don't think you'll ever get them to work with a factory PCM. If anyhing you'll fry the injector circuit.

[timmydatoolman]

If they are truly low impedence, I don't think you'll ever get them to work with a factory PCM. If anyhing you'll fry the injector circuit.

exactly, thats why i am hoping someone here knows for sure if they are.

[KicknAsphlt]

Do NOT go with Venom Injectors!!! They may be low-priced, but there's a reason for that. There's a standing warning on the Supra boards about them, their injectors aren't matched to each other as far as flow rates, with a wide range of fluctuation for a given flow rate. There's been several guys that have fragged their motors with those injectors due to the difference in flow rates between the injectors. For example, say you buy a set of 550cc (~52#) Injectors. Now, send 'em off to get flow tested. You'll most likely get back a result of anywhere between 3XXcc and 5XXcc in flow rate for that set of '550cc' injectors. I used the 550cc reference because that's a common upgrade for the Supra guys, but the concept works across the board. Just warning you, but ultimately it's your decision on whether you get them or not. If you do decide to get a set from them, I HIGHLY recommend you send them to Marren or RC Engineering to have them flow tested before use.