Bottle Mounting Question.

[G-Man]

Where have you guys mounted Your Nitrous bottle? Everybody here tells me to put it in the back seat. TIA
G-Man

[blk00rt]

thats where mine are mounted, just have to remember to install a blow down tube if its inside the cab.

[1evilrt]

In the left rear of the bed, back by the tailgate.

[grapejuice1998]

In the left rear of the bed, back by the tailgate.

Right/rear by the tailgate on mine. It's out of the way, but handy. Plus it adds a little weight over that tire for some extra bite at the track.

I know a lot of people mount them in the cab, but that just makes me nervous. If you wire the heater to a constant + and accidentally leave it on with the valve closed...BOOM!!!
http://i54.tinypic.com/rmr7dx.jpg

[1evilrt]

Right/rear by the tailgate on mine. It's out of the way, but handy. Plus it adds a little weight over that tire for some extra bite at the track.

I know a lot of people mount them in the cab, but that just makes me nervous. If you wire the heater to a constant + and accidentally leave it on with the valve closed...BOOM!!!
http://i54.tinypic.com/rmr7dx.jpg
I agree with Alan, the cab is touchy, I would've put mine on the rt hand side but that spot is where the battery is.:biggthumpup:

[G-Man]

Right/rear by the tailgate on mine. It's out of the way, but handy. Plus it adds a little weight over that tire for some extra bite at the track.

I know a lot of people mount them in the cab, but that just makes me nervous. If you wire the heater to a constant + and accidentally leave it on with the valve closed...BOOM!!!
http://i54.tinypic.com/rmr7dx.jpg

I'm with ya' Alan, I've never seen a pic of a bottle exploding, that's enough for me, My first idea was right side of the bed by the tailgate, for weight distribution.
I don't have a bottle heater yet, or a blowdown? tube either,
Thanks guys,
While i got your attention, would you care to guess my 1/8 mile ET improvement? with say 150 shot? I can run low 9's now.

[blk00rt]

Right/rear by the tailgate on mine. It's out of the way, but handy. Plus it adds a little weight over that tire for some extra bite at the track.

I know a lot of people mount them in the cab, but that just makes me nervous. If you wire the heater to a constant + and accidentally leave it on with the valve closed...BOOM!!!
http://i54.tinypic.com/rmr7dx.jpg

looks like someone did not have a blow down tube installed. If the pressure disk was in this would not have happened.

[1evilrt]

It all depends on your traction, If your sprayin out of the hole you better have good tires and a traction device!:burnout:

[G-Man]

It all depends on your traction, If your sprayin out of the hole you better have good tires and a traction device!:burnout:

Yep, I hope that I'm Prepared, I do think i am. I got the New tires and a "traction device" Lol

[grapejuice1998]

looks like someone did not have a blow down tube installed. If the pressure disk was in this would not have happened.

If the bottle valve is closed, the disc is isolated from the bottle pressure so it goes BOOM!
Even if you don't have a blowdown tube installed, if the bottle valve is open, the disc will burst and vent the bottle wherever it happens to be at the time. That's why they have a tube, to vent it outside the cab.

[grapejuice1998]

While i got your attention, would you care to guess my 1/8 mile ET improvement? with say 150 shot? I can run low 9's now.

Probably low 8's with traction.

[Addicted2Blue00]

I'm with ya' Alan, I've never seen a pic of a bottle exploding, that's enough for me, My first idea was right side of the bed by the tailgate, for weight distribution.
I don't have a bottle heater yet, or a blowdown? tube either,
Thanks guys,
While i got your attention, would you care to guess my 1/8 mile ET improvement? with say 150 shot? I can run low 9's now.
my guess 8.1-8.4 with traction, im tryin to get high 8s before puttin in a bottle

[mtlcafan79]

Here's another lesson with nitrous. Do not crack the valve, close the valve, and then turn on the heater without opening the valve again! The pressure never goes up for the sensor and the heater just stays on. Bad news!

[Five9Dak]

oh jeez....

[Special Ed's R/T - Yaaaay]

mount it where Adobe Dave does, in the garage :jester::biggthumpup:

[SinCity R/T]

mount it where Adobe Dave does, in the garage :jester::biggthumpup:

:laughat::owned:

[G-Man]

my guess 8.1-8.4 with traction, im tryin to get high 8s before puttin in a bottle

I was trying to get in the 8's before syraying also, but I got a deal on this kit, so plans have changed, I maybe in the 8's anyway, since the 4bbl TB, I haven't been to the track with it yet.

[grapejuice1998]

I was trying to get in the 8's before syraying also, but I got a deal on this kit, so plans have changed, I maybe in the 8's anyway, since the 4bbl TB, I haven't been to the track with it yet.

Is the kit all one brand, or is it bits and pieces of different kits?

[G-Man]

Is the kit all one brand, or is it bits and pieces of different kits?

Yea it's all Nitrous Express parts,the only parts missing are some of the jets

[rhurley]

I mounted mine Passenger side bed. Had my line come out of that little hold down hole thing

[1evilrt]

mount it where Adobe Dave does, in the garage :jester::biggthumpup:

LOL, i cant say much, lately my bottle has been holding by basement door open!