Vacuum/pressure lines for KenneBell

[Activate]

I want to know something about the vacuum/pressure lines.

I have installed mine today(I bought it used), and do not know where to put these lines :

http://img.photobucket.com/albums/v140/activate1/kb.jpg


I have colored them red, I think I have MAP sensor right because it must see the manifold pressure but I am not sure about the bypass valve.

If I suck on the line the valve travels but if I blow in it nothing happens.

Can someone tell (help) me?

(Thanks for the picture 01dakotaqc)

Thanks and greetings,

Erik.

[DakRat33]

Kenne Bell? Nice

where'd u get it?

[Activate]

I have bought it from a guy on the dakota-durango forum!

Greetings,


Erik.

[1hotkadota]

I have colored them red, I think I have MAP sensor right because it must see the manifold pressure but I am not sure about the bypass valve.

If I suck on the line the valve travels but if I blow in it nothing happens.

Can someone tell (help) me?

(Thanks for the picture 01dakotaqc)

Thanks and greetings,

Erik.

It should stay closed when you blow on it so that when the TB blades are open and boost is being made, it is "blowing" into the bypass valve keeping it closed. Now when you let off of the gas and the TB blades close, there will be a vacuum in the manifold, opening the bypass valve, and releasing the pressure from the intake saving your compressor. I hope that was coherent enough to understand.:jester:

Good luck dude.

[Activate]

Thanks for the answer!!

So it must be working then!

Thanks and greetings,


Erik.