PDA

View Full Version : Painted Water Pump with Threaded Heater Hose 40 shipped

ADakotaRTGuy
08-12-2010, 05:19 PM
It was going to go back on my truck, but I am going to get an older style one so that I can use a bolt on pulley and use my billet pulley I just bought. Only about 1500 miles on it and it works great, professionally painted (ie, not me). The heater hose fitting is also tapped to a 1/2 npt so that you can run some nicer hoses to the firewall vs the stock stuff.

So 40 shipped and its yours.

http://i35.photobucket.com/albums/d197/Davidsalazar03/CIMG2722.jpg

http://i35.photobucket.com/albums/d197/Davidsalazar03/CIMG2723.jpg
ADakotaRTGuy
08-17-2010, 08:24 PM
Bump...
1BAD99RT
08-18-2010, 06:03 AM
Nice setup! Never thought of taping that hole..lol (that sounds soo wrong)
ADakotaRTGuy
02-02-2011, 06:52 PM
Bump..
WhiteRT
02-02-2011, 06:54 PM
Bump..

6 months later you bump - LOL!
ADakotaRTGuy
02-02-2011, 06:56 PM
Better late then never right? haha
xbxjunkie
02-02-2011, 07:10 PM
that threaded hole wouldn't be the one where the o-ringed tube used to be...is it?

that's a good idea...i might take this
ADakotaRTGuy
02-02-2011, 07:11 PM
that threaded hole wouldn't be the one where the o-ringed tube used to be...is it?

that's a good idea...i might take this

Yes it is. Had it machined out to the 1/2 NPT to use some nicer tubing and clean up the engine a little. But went to a bolt on one.
bfranzel
02-02-2011, 11:04 PM
Yes it is. Had it machined out to the 1/2 NPT to use some nicer tubing and clean up the engine a little. But went to a bolt on one.

tapped mine and stuck a plug in it!
jstahl1985
02-03-2011, 12:11 AM
i'll take it...pm sent
ADakotaRTGuy
02-03-2011, 03:58 AM
SOLD :biggthumpup: