PDA

View Full Version : LM2 Permanent install?



BluRT00
05-21-2010, 01:28 PM
Have any of you with the LM2 gone and installed it Permanently? Instead of using the cig outlet. I am about to bite the bullet and buy the LM2. So I don't have to run more wires and tap in for the TPS, Map etc... Cause right now I have my LM1 on a key ignition source fused with no issues.

emwhiteR/T
05-21-2010, 04:12 PM
The handheld is kind of bulky. I don't know where you plan to store it?

If you have an iphone or smart phone, check this thing out:
http://www.dakota-durango.com/forum/showthread.php?t=115300

You will still need a separate Wideband AF for it. Either the LM2 or standalone.

Read more about it here:
http://www.innovatemotorsports.com/products/ot2.php

Aves
05-21-2010, 07:23 PM
I ran my power cord under the center console and have the lm-2 inside console. Also have a gauge wired to it and in the 3pillar gauge pod. So I just leave the handheld and all wires inside the console til I wanna data log. Pull it out and grab cable and plug it into the obd port.


Troy

bfranzel
05-21-2010, 08:59 PM
I ran my power cord under the center console and have the lm-2 inside console. Also have a gauge wired to it and in the 3pillar gauge pod. So I just leave the handheld and all wires inside the console til I wanna data log. Pull it out and grab cable and plug it into the obd port.


Troy

thats what i did except no guage pod. i need one bad. i took the lid of my center counsole apart and put some 1/4" althread threw and have the logger attatched to the lid!

PeteRT
05-23-2010, 05:58 AM
i have yet to relocate a power source for it, but you get the idea:

http://www.dakotart.com/forum/showthread.php?t=10047

pete