Activity Stream

I like that one. $11 shipping though, unless I spend $70 some dollars more...

Thanks for the tip on the vortex install. that does not seem like a bad way to go.

JEGS 53250 is the partnumber for black but you have an idea i see the price is 20.50$ on sale i paid 60 for it

i use a billet waterneck from jegs specially for the magnum engines . you can reuse it and it seals good . it also comes with stainless hex bolts and...

I teed off the oil pressure sending on the top of the block behind the intake manifold. With the factory block I tapped the pan for the return...

I've actually already got one, just wanted to know how it compared.

TexasSpeed has good cams. Damn someone just had half off ls cams too. Ill try to remember who it was.

is there not any free ports in the block? Maybe I could add a Tee where the pressure sending unit goes.

I am currently running the billet with o ring on my 408 with the the old style M1. Because I want to run AC without hacking up the mounting bracket I...

Likely go with an OE type replacement.

Oh, and how much boost?

What are you running for a camshaft? I'm doing a 6.0 LQ4 with LS3 heads, an S480, and a custom boost cam in my AF RC.

Removed Vortech from mock engine. Headed to Vortech tomorrow to have it dismantled for Powdercoat.

Im picking supply from the oil filter adapter for remote cooler and 10 an fittings welded to the oil pan for drains but untested yet hope it works...

did you have the journals checked for spec and any taper ? my 4.150" crank for my big block got locked when i ran the main cap bolts down, not even...

:biggthumpup:

Replaced my front wimpy brakes to the 03 Durango, replaced the Belltech drop springs back to stock RT springs, added 2 1/2 shackle lift on rear to...

M1 price drop!! Get your truck a special gift this holiday season :drtc_logo001::r/t smile:

Yes they were. There is no one more stupid about technology than me. Your info would not open on my Mac. So I went to "2000 Dakota FSM" with Google....

Magnum engine torque stuff should be the same for most years: ...

Anyone happen to know the torque specs on the therm housing? I'm thinking around 150 inch pounds?

I've used both billet and stock. The billet one sealed well on the first use, but needed a new o-ring if to get it to seal again after I replaced the...

Stock on race truck, billet on daily due to centered housing on old style 4bbl. Must use old cast steel or billets for those.

Mocked up my V1-T on a spare block. Test fitted Todd’s 2.0 1/2” Vortech brackets and figured out hardware to order. Parts are now ready to drop off...