Activity Stream

Well I found another one so I am all set. You can close this thread if you want. Thanks guys.

Decided to start the spintech exhaust swap finally, well.. I just cut my old mufflers off lol, . Hoping to get the X pipe and exhaust on there next...

:biggthumpup:

Passenger’s side wheel at full lock to the right. This is the closest the tire will ever be to the pipe. I should be good with this.

:r/t smile:

fixed and took a 500+ mile trip afterwards almost all highway 70+mph. i made it there and back. thats a win lol 16.8mpg

Made a couple of merge collector templates to better see the actual size for placement ideas. The left side is where the primary tubes enter. The...

Parts list 52039248 left and right spring for Dakota. Also 52039249 as left and right. Some reference 49 as being for Durango. Also lists ZAK,ZNK as...

Well I went with bell tech springs for a v8 I did not cut the metal bump stops off control arms even when I had stock springs in it would bottom out ...

The way I know the springs are different from side to side, is I used a spring rate checker to find out why my truck was bottoming out. The lowering...

Installed Hotchkis TVS on my 2000 and don't recall the coils having a left and right. Nor the original springs. Sure surfing the parts lists checking...

Tack-welded the two sections together. Then used a hose clamp to tentatively position a third bend, since at this point, I’m not exactly sure where...

It's not the shocks that is letting your truck bottom out, it's the springs. Springs are what hold the truck up, not the shocks. A Dakota R/T has a...

Thanks guys!

Lookin' good, Richard! :r/t smile:

:r/t smile:

Thanks!

Looks good, the finished exhaust is going to look really cool.

I can also use the header modeling kit to help with the routing of the 3” side exhaust tubing to get a better idea before cutting any tube. The...

I bit the bullet and picked up the Icengineworks modeling system for 1 3/4" tube. This will allow me to try various things without potentially...

Combined filter and pressure regulator.

I like this forum better than FB, too many negatives on FB. Unfortunately, there aren't a lot members on this forum anymore, so the...

So I did the 2003 durango brake upgrade and had it aligned at a great shop and they found the sway bar was mounted a little more to the driver side...

Your correct, should be replaced when replacing fuel pump.. because it has a filter.

It is both a fuel filter and a pressure regulator!

It is both a fuel filter and a pressure regulator!

It is both a filter and pressure regulator!

This is not a pressure regulator on top of basket as shown, this is actually a fuel filter.:stirringthepot: