Activity Stream

It has been done. I have a set to do myself and seen a couple out there.

Funny! It does look like an old intake turtle. :biggthumpup:

Can I vote to call them exhaust turtles lol? :jester:

The next step will probably be to make the merge collector.

Fabricated the header spear (aka, spike, pyramid, bullet, etc.) that will be welded to the end of the header primary pipes within the collector, to...

Thanks for input guys I’m leaning toward the 408 I already have heads from pie headers and intake cam ect but I keep getting tempted with that damn...

Plausible lol

I suppose you could also make a mounting pad out of steel plate/sheet to better distribute the load over a wider area, if you already had a 4"...

:biggthumpup:

Looked in my user manual (10k Bendpak symetric 2-post) and 4.25" is their minimum (6" recommended) in concrete cured for at least 28 days and at...

You can do a lot of things lol. 4" is fine for a 4 post and if you're not picking up anything heavy you can probably even get away with it for a two...

Yeah, this schit just make me giddy! :jester:

Good to know. I know guys who are doing it with 4" of concrete.

:rockwoot:

Recommended depth is usually 6" for a ~10k pound 2 post. My shop is 8" except for under where the lift lives. There it dips down to a little over a...

Sure is. The blade gap is set at the factory for the maximum thickness of the shear. I'll have to close the gap up some for a cleaner cut in...

Did the 408 and intake sell?

Nice! Always fun to acquire new toys.

Well... This from an old fart that would rather drive mine than have it sit for years. I'd build your engine. Bored 360 or 408 will be quicker and...

Deal fell thru. Looking at another newer one. The concrete floor where I plan on installing it should be plenty thick. If i had to guess more...

If I'm looking at the right lift, that is a two post lift. What is concrete thickness for support for a two post lift? Is thickness of concrete...

I checked their website, and they appear to have replacement parts available, but I didn't look specifically for the item in consideration. Good...

If you keep it a 360, the Edelbrock RPM heads provide an increase in flow while maintaining good port velocity. One thing to keep in mind is the...

I would confirm replacement parts availability for it.

I don't have any experience with it, but I sure would like one. I just don't have the headroom for it.