Activity Stream

Yes tried that and I don’t think it helped going to try it a couple of times and then wait to get a hold of Ryan and see if tune will fix it right...

Mine too.

Did you perform an idle sync?

Thanks Mike I have to find someone else with a scanner to do it myself the guy borrowed one from somebody but after driving it it has kinda tuned...

How hard was is to set up the turn on/off the cooling fan with HP Turners? Did you use the MPVI2 or HPVI2+? I've been looking for HPVI2+ on...

Got my fan turning on at 185! best mod so far getting rid of the clutch fan for good!

Bump

sent ya a PM.

I still have it. Robert

When mine was doing that, I checked the sync and it was at +10. It was after someone had set it to +4, it ran good for about a month and then I...

I don't imagine that you still have this? But if you do, I'm interested.

You can have some one weld a plate in place for now, you eliminate that gasket or chance of it blowing out

Mine the same.

You can also buy a plate to replace stock one. They are a little pricey and I personally would invest in a better manifold VS installing one of...

When I had my R/T, I made an aluminum plate to replace the sheetmetal pan on the bottom of the stock intake manifold. Once it was on and sealed up,...

I found and bought a new MPVI2 with 9 credits for $570 with tax. Alot of $ to just turn on the fan earlier but im sure it will come in handy if I...

Thank for the response my guy to supposedly set it +3+4 I didn’t see him actually do it so I say supposedly so the truck runs ok but I’m getting a...

The earliest information I could find on this was by Speed Tweaks around the early 2000's. There is/was some controversy on the reliability of Speed...

I'd agree with 0 to +4, seems to be the most popular consensus. However, I have never been able to find anything concrete in this regard. Years...

What Go FastGary said, most engines are happy 0 to +4. When I set mine, the number moved around some, so I set it at +2. Some dealers can set it,...

Set to 0 to +4. My tuner recommends +4, I believe my daily was happier at +2 with similar mods to what you have. Dealer should also be able to set...

Don’t have any scanners trying to find the snap on mt2500 any other scanner’s work and what should I set it to when I can

The further back the exhaust/pipes go, the quieter it should be. There will be greater cfm flow loss, but as long as the system flows enough for...

Do you have a Solus scanner?

4 mufflers ? I thought about redoing my exhaust all the way to the back by the roll pan, but put the spintechs all the way back there like my jeep,...

I have seen that before, probably 40 some years ago on big inch engines to keep them fairly quiet and still flow well.

Check out the muffler set up on this GTX with a hemi. It used (4 qty) 3” Cadillac mufflers. (Back in the day there were fewer performance options...

Hotchkis coils in the front, Belltech leaf springs int he back. Still a little high, but I didn't want to do hangers (or blocks) in the back and...