Activity Stream
-
Older Activity
-
Today, 12:56 PMHow hard was is to set up the turn on/off the cooling fan with HP Turners? Did you use the MPVI2 or HPVI2+? I've been looking for HPVI2+ on...10 replies | 414 view(s)
-
Today, 04:05 AMGot my fan turning on at 185! best mod so far getting rid of the clutch fan for good!10 replies | 414 view(s) -
Today, 12:40 AMBump1 replies | 208 view(s)
-
03-22-2023, 10:57 PMsent ya a PM.3 replies | 256 view(s)
-
03-22-2023, 10:18 PMI still have it. Robert3 replies | 256 view(s)
-
03-22-2023, 09:18 PMWhen mine was doing that, I checked the sync and it was at +10. It was after someone had set it to +4, it ran good for about a month and then I...8 replies | 320 view(s)
-
03-22-2023, 12:27 AMI don't imagine that you still have this? But if you do, I'm interested.3 replies | 256 view(s)
-
03-21-2023, 05:08 AMYou can have some one weld a plate in place for now, you eliminate that gasket or chance of it blowing out3 replies | 114 view(s)
-
03-20-2023, 10:58 PMMine the same.18 replies | 3014 view(s)
-
03-20-2023, 05:42 PMYou can also buy a plate to replace stock one. They are a little pricey and I personally would invest in a better manifold VS installing one of...3 replies | 114 view(s)
-
03-20-2023, 02:21 PMWhen I had my R/T, I made an aluminum plate to replace the sheetmetal pan on the bottom of the stock intake manifold. Once it was on and sealed up,...3 replies | 114 view(s)
-
03-18-2023, 05:52 PMI found and bought a new MPVI2 with 9 credits for $570 with tax. Alot of $ to just turn on the fan earlier but im sure it will come in handy if I...10 replies | 414 view(s)
